TERRALUX DLR6H Install - Manual

TerraLUX Inc. Document P/N 025000066 – E
1-866-498-1564
www.terralux.com
 WARNING - RISK OF FIRE OR ELECTRIC SHOCK. LED RETROFIT KIT
INSTALLATION REQUIRES KNOWLEDGE OF ELECTRICAL SYSTEMS.
IF NOT QUALITIED, DO NOT ATTEMPT INSTALLATION. CONTACT A
QUALITIED ELECTRICIAN.

WARNING - RISK OF FIRE OR ELECTRIC SHOCK. INSTALL THIS KIT
ONLY IN LUMINAIRES THAT HAVE CONSTRUCTION FEATURES AND
DIMENSIONS SHOWN IN THE DRAWINGS “MINIMUM 7.5 INCH (19 CM)
DIAMETER REFLECTOR, AND 7 INCH (18 CM) HEIGHT”
 WARNING - TO PREVENT WIRING DAMAGE OR ABRASION, DO NOT
EXPOSE WIRING TO EDGES OF SHEET METAL OR SHARP OBJECTS

DO NOT MAKE OR ALTER ANY OPEN HOLES IN AN ENCLOSURE OF
WIRING OR ELECTRICAL COMPONENTS DURING KIT INSTALLATION.

THE RETROFIT ASSEMBLY IS ACCEPTED AS A COMPONENT OF A
LUMINAIRE WHERE THE SUITABILITY OF THE COMBINATION SHALL
BE DETERMINED BY UL OR AUTHORITIES HAVING JURISDICTION.
 SUITABLE FOR DAMP LOCATIONS
THIS RETROFIT KIT IS FOR INSTALLATION INTO INDOOR RECESSED NON-IC TYPE CEILING
MOUNTED DOWN LIGHT LUMINAIRES THAT ARE USED IN NON-FIRE-RATED INSTALLATIONS
ONLY. CHECK FOR THIS MARKING ON THE LUMINAIRE, OR WITH THE BUILDING CODE
AUTHORITIES HAVING EXPERTISE IN THIS AREA PRIOR TO INSTALLATION OF THIS RETROFIT KIT.
MODELS TLK-DDL-B04XX, TLK-DDL-D04XX, TLK-SDL-B04XX, TLK-SDL-D04XX
TLK-DLR7H-B04XX, TLK-DLR7H-D04XX, TLK-DLR6H-B04XX, TLK-DLR6H-
D04XX
SINGLE AND DUAL DOWNLIGHT LED RETROFIT INSTALLATION INSTRUCTIONS
INCLUDED COMPONENTS – (KITS MAY BE BULK PACKAGED)
 (1) LED LIGHT MODULE, MODEL TLK-DDL-B04XX, TLK-DDL-D04XX, TLK-SDL-B04XX, OR
TLK-DDL-D04XX
 30” METTALIC CONDUIT WITH JUNCTION BOX FITTING
 (3) WIRE NUTS
 (2) # 8 x 1-1/4 IN. SELF-TAPPING SCREWS
 (1) UNIFIED DIFFUSSER or (1 OR 2) INDIVIDUAL DIFFUSSERS
USER REQUIRED TOOLS
 DRILL WITH A 1/4 INCH HEX DRIVER BIT
 WIRE CUTTERS
SAFETY PRECAUTIONS
 INSTALLATION TO BE PERFORMED BY A QUALIFIED LICENCED ELECTRICAN
 ENSURE THAT POWER IS TURNED OFF AT THE BREAKER PANEL PRIOR TO INSTALLATION
INSTALLATION STEPS
1. SHUT OFF POWER TO DOWN LIGHT FIXTURE.
2. REMOVE BULBS FROM FIXTURE. DISPOSE OF OR RECYCLE PROPERLY.
3. PULL DOWN ON REFLECTOR/TRIM RING TO
REMOVE FROM MOUNTING FRAME
4.
DETACH LAMP SOCKET CUP FROM BACK OF
REFLECTOR/TRIM RING AND SET ASIDE.