TERRALUX DLSQ8 Install - Manual (Page 2)

TerraLUX Inc. Document P/N 025000110
1-866-498-1564
www.terralux.com
9. REINSTALL BALLAST WITH COVER PLATE AND INSTALL LED DRIVER WITH COVER PLATE OVER THE
FIXTURE’S J-BOX OPENINGS. ENSURE THAT BOTH COVERS ARE PROPWERLY POSITIONED AND
FULLY LATCHED IN PLACE.
10. ROUTE LED HEAD ASSEMBLY AROUND OUTSIDE OF FIXTURE SUPPORT POSTS, AND OUT THROUGH
TRIM HOUSING OPENING.
11. GUIDE LED HEAD ASSEMBLY THROUGH OPENING IN TRIM HOUSING BEING CAREFUL NOT TO
SCRAPE AGAINST THE LED SURFACE.
12. INSERT TRIM HOUSING BACK INTO FIXTURE, AND POSITION THE LED MOUNTING BRACKET INTO
BOTTOM OF TRIM HOUSING SUCH THAT THE ROUNDED CLIPS ALIGN WITH THE TRIM HOUSING
OPENING. SECURE BOTH TRIM RING HOUSING AND LED MOUNTING BRACKET TO THE FIXTURE
USING WING NUT REMOVED IN STEP 3.
NOTE – BASED ON THE BOTTOM DIMENSIONS OF SOME TRIM HOUSINGS, THE MOUNTING SCREW
MAY NOT BE LONG ENOUGH TO INSTALL THE LED MOUNTING BRACKET. IF THIS HAPPENS, THREAD
THE PROVIDED 3/8” THREADED METAL STANDOFF ONTO THE TRIM HOUSING MOUNTING SCREW
BEFORE INSTALLING LED MOUNTING BRACKET.
13. REMOVE THE PLASTIC PROTECTIVE COVER FROM OVER THE LED’S AND DISCARD.
14. INSTALL DIFFUSOR BRACKET OVER LED’S AS SHOWN. DIFUSSER BRACKET SHOULD FULLY SEAT IN
PLACE
15. PRESSING DOWN ON THE CORNERS OF THE DIFFUSER BRACKET, FIRMLY SEAT THE LED HEAD
ASSEMBLY INTO THE LED MOUNTING BRACKET. NOTE: THE LED MOUNTING BRACKET IS SELF-
ALIGNING AND WILL GUIDE THE LED/DIFFUSER ASSEMBLY INTO PLACE.
16. TURN POWER BACK ON AT THE BREAKER PANEL AND VERIFY OPERATION