Crimestopper Security Products CS-2016FM - Manual (Page 3)

TRANSCEIVER / PAGER-REMOTE
PAGER / REMOTE TRANSCEIVER:
#1 ARM/
LOCK
#4 ENGINE
START/STOP
#5
RECALL /
CAR I OR II
#3 TRUNK
POP
#2 DISARM/
UNLOCK
ANTENNA
START
FIXED
LCD
SCREEN
PM
The hand-held remote transceiver is used to send and receive
information from the vehicle. The Control Module transmits High
Frequency FM signals from the vehicle to your over long
distances. Your range will vary depending on location, terrain,
and local RF noise/interference. This system is not guaranteed
to page you if you are behind concrete walls, underground, in a
large structure, or in an area with high levels of electronic
interference. Handle the pager/remote with care if the LCD
display and/or the electronics may be damaged if subjected to
abuse. The AAA Cell 1.5V alkaline battery can easily be
replaced by sliding open the battery access door on the back of
the remote. Battery life will vary depending on usage. The LCD
screen will display a low battery icon when the battery is low.
For more on range, see “Range Questions” on page 15.
ACTIVE 2-ZONE LCD DISPLAY:
The unique LCD screen includes both a Dot Matrix animated display and a vehicle icon. It is designed to show you
both Icon-based information and animated messages in real time as it is happening. When the alarm is disarmed or
armed with no activity to report, then dot matrix portion of the screen will remain BLANK.
BUTTON 1(Lock Symbol):
BUTTON 5 (On side of remote):
• Press and Release to Recall the
last message from the LCD screen
• Press and Hold for 3 seconds to
change from Car 1 to Car 2 (Only
for use with 2-car operation).
• Press 5 times to Disable/Enable
audible beep tones from the
remote. (Remote will vibrate twice
to confirm silent mode)
• Press and release to Arm/Lock system.
• Press and Hold for more than 3 seconds to activate “Panic” feature.
BUTTON 2 (Unlock Symbol):
• Press and release to Disarm/Unlock system, or reset a cycle.
BUTTON 3 (Trunk Symbol):
• Press and Release to activate trunk pop (Auxiliary output #1) Optional
Feature.
• Press and Hold to activate a second optional feature (Auxiliary output
#2).
BUTTON 4 (Key):
• Press and release to Start/Stop engine.
3