Seite 3 – SUNBOUNCE THE-CAGE User Manual

Page 3

Attach the fabric to the corners of the frame.
Take a BUNGEE-SNAKE and thread it in
the plastic ring at the corner of the fabric, as
well as in the hole at the inside of the corner
connection.

There are plastic loops alongside the edges
of the fabric. Every second loop needs to be
mounted to the frame – use BUNGEE-
SNAKES.

Make sure that all safety buttons lock into
the designated holes. Secure THE CAGE
against wind (as shown in 25-27). Then,
mount the side panels to the frame using
BUNGEE-SNAKES.

Lift up the upper part of the tubular frame
and place it on the connecting elements of
the lower half of the frame. If you have an
assistant, lift up two diagonally opposite
corners at the same time.

The upper side of the CAGE can be used
as a diffusor. To do so, open the zippers on
the side of the black cover panel and roll
them up towards the back. Attach the rolled-
up cover panel with the yellow strings.

The black back panel can be opened. Just
unzip the two zippers on the sides.

Also, mount the side panels to the frame at
the bottom edge (with BUNGEE-SNAKES).

Roll up the rear panel and attach it with the
four yellow strings.

You can mount arbitrary backdrops into THE
CAGE. As an optional supply you can order
a black duvetine fabric with hooks at the
upper edge and on the sides.

Attach the backdrop fabric to the plastic
loops at the rear panel. Thread BUNGEE-
SNAKES in the fabric loops and tie them.

Attach the fabric to the loops on the side
and straighten it out. Pull the hanging fabric
to the front and you'll create a cove.

THE CAGE with opened rear panel.