SUNBOUNCE THE-CAGE - Manual (Page 2)

Scope of delivery
Aluminum and plastic parts for the tubular
frame (ROLLERBAG optional), fabric
(SCREEN-SAVER optional). Following parts belong to the tubular frame:
a) 4 poles without connecting elements
b) 12 poles with connecting elements
c) 8 poles with corner connecting elements
d) 60 BUNGEE-SNAKES
a)
b)
c)
d)
The cage consists of a tubular frame which
forms a cube, a fabric with two side panels,
and a back panel with a roof.
Take 4 pole pieces with a corner connecting
element (c). Connect each of them with a
pole with a straight connecting element (b). Now attach the four corner elements to the
even ends of the poles. Make sure that the
safety buttons lock into the designated
holes.
While putting the square onto the floor,
make sure that the holes of the corner
connecting elements are upturned. Take frame pieces (a) with connecting
elements at the end. Insert them from the
top into each corner connecting element.
You have assembled the lower half of the
tubular frame.
Repeat these steps with the left-over frame
pieces and you'll have the upper half of the
tubular frame. Set up the upper half of the frame in a way
that allows you to conveniently hook in the
fabric and adjust it. Spread out the fabric. The white diffusor
fabric needs to point upwards. On one of
the four sides you will find a tag (Greg
Gorman). This tag indicates where to find
the open side of the fabric.
Make sure that the safety buttons lock into
the designated holes.
b) c)
Following parts belong to the tubular frame:
a) 4 poles without connecting elements
b) 12 poles with connecting elements
c) 8 poles with corner connecting elements
d) 60 BUNGEE-SNAKES
c) b)
c) b)
c)
b) c)
b)
1 2 3
4 5 6
7 8 9
10 11 12
a)