SUNBOUNCE LOCATION-TRUCK - Manual

TWO YEAR LIMITED WARRANTY
Sunbounce shall warrant this Cart to be free from material or workmanship defect for a periodof two years
from date of purchase. Sunbounce will replace without charge any original part that is determined by
Sunbounce to be defective. Under the terms of this warranty, however, transportation and labor charges are
not covered hereunder. Failure due to accident, abuse or normal wear ls not covered by this warranty. This
warranty gives you specific legal rights and you may also have other rights, which vary from country to coutry.
Step 1: Using the Screwdriver provided, remove Hubcap, Bolt, and Lock Washer from
the end of the Axle.
Step 2: Lubricate the Axle and Black Plastic Wheel Bushings with the grease that is
provided in the plastic cup.
Step 3: Install the Wheel on Axle.
Step 4: Install Hubcap, Bolt and Lock Washer in order shown l above, taking care not
to cross thread the Bolt. Tighten securely and the cad is ready to use!
Notice
This FOLDIT cart is designed to hold up to 150 kg. This cart was not designed to care people,
especially 11 mildred. The user assumes the risk of any personal injury if used for a purpose other
than what the cart was designed for.
Caution
California Sunbounce recommends a maximum tire pressure of 2,5 bar. In extreme heat conditions
(100 degrees Fahrenheit or more) 2 bar maximum pressure should be used. Use hand pump 1 only.
Do not inflate over 2,5 bar.
California Sunbounce wants you to be completely satisfied with our products. If you have any claims
to make regarding freight damage or other problems, please contact us.
Fold-It LOCATION-TRUCK
SUNBOUNCE GmbH · Buchenring 8 - 10 · 21272 Egestorf · Germany
Telefon: +49 (0) 4175 - 80 88 79 87 · Telefax: +49 (0) 4175 - 80 88 79 67
E-Mail: [email protected] · Internet: www.sunbounce.com
© 2013 SUNBOUNCE GmbH. All rights reserved.