SoundOff Signal 400 Series Remote Amp Box - Manual (Page 5)

2. Buzzer: Audible tone from control panel whenever operator
presses push-button or changes position of slide/rotary
switch
ON = Buzzer enabled
OFF = Buzzer disabled
4. Hands Free Mode: (Alternate Horn Ring Control Must
be Disabled) Activates the siren tone when operator
momentarily presses on Vehicle Horn.
ON = Enabled
OFF = Disabled
5. Power Down: Determines whether siren will operate when
ignition input has no voltage
ON = Siren will operate without voltage
on ignition input
OFF = Siren is disabled when no voltage
is present on ignition input
SLIDE SWITCH SETTINGS:
1. Press and hold Auxiliary Push-Button “1” and “4” until slide
switch #2 indicator LED flashes.
2. Press Auxiliary Push-Button “1”, “2” or “3” depending on
which configuration for the slide switch is required.
6. Horn Ring Standby Tone: (Hands Free Mode must be
disabled for this function to work)
(Alternate Horn Ring Control Must be Disabled)
Determines which tone to output when siren is in standby
and vehicle horn is pressed
ON = Air Horn
OFF = Wail Tone
7. 8 Second Buzzer alert: Provides audible beep whenever any
auxiliary switches are ON or level 1,2, or 3 is active.
ON = Enabled
OFF = Disabled
HIGH
LOW 2
6 5
3
7
4
Setting PA Volume:
1. Press and Hold Auxiliary Push-Button “1” and “2” until slide switch
#2 and #3 indicator LED flashes.
2. Depress and hold PA switch on microphone and press Push-button
“1”-“8” depending on volume required. When correct
volume is determined, press Radio Rebroadcast and the
volume setting will be permanently stored.
1. Alternate Horn Ring control: Custom operation of vehicle horn
when pressed. Refer to figure below for details.
ON = Enabled
OFF = Disabled
2. Alternate Horn Ring control option: (Alternate Horn Ring
Control must be enabled). Custom operation of vehicle
horn when pressed. Refer to figure below for details.
ON = Option 2
OFF = Option 1
ALTERNATE HORN RING CONTROL
OPTION 1 OPTION 2
STANDBY OEM HORN OEM HORN
LEVEL 1 OEM HORN OEM HORN
LEVEL 2 Air Horn or Wail
Button Tone while
Pressed *
Tap to Turn On Warning Tone,
Tap again to Change Warning
Tone. Press and Hold for Air
Horn Tone
LEVEL 3 Tap to turn ON
Warning Tone, Tap
again to change
Warning Tone. Press
and Hold for Air Horn
Tone
TONE
SWITCH OFF:
Air Horn Tone
or Wail Button
Tone while
Pressed *
TONE
SWITCH ON:
Tap to change
Warning Tone,
Press and Hold
for Air Horn
Tone
BACKLIGHT INTENSITY:
While pressing RADIO REBROADCAST BUTTON,
press Auxiliary Button 1-8 to adjust backligh intensity.
Button 1 = Lowest intensity, Button 8 = Highest intensity.
Backlight must be enabled by the Gray wire on CN6.
ALTERNATE MODES:
1. Press and Hold Auxiliary Push-Button “2” and “6” until
Slide Switch indicator #1 and indicator #2 LED
OTHER MODES:
1. Press and Hold Auxiliary Button “1” and “5” until slide switch
#1 and #3 indicator LED flashes.
1. Horn Ring Activation: Determines when pressing the Vehicle
Horn will activate siren tone
OFF = Enabled only when slide switch is
in level position 3
ON = Enabled whenever siren is ON
3. Speakers diag LED disable: Disabling S2 LED does not
turn off secondary speaker channel
ON enable S2 LED (200W system)
OFF disable S2 LED (100W system)
3. GUN LOCK SECURITY:
ON = Operator must press Standby button
within 1 second after pressing 8
second time delay button to active
switch
OFF = 8 second time delay switch is
activated immediately when
pressed
7
SLIDE SWITCH SETTINGS
MODE RELA
Y
OUTPUT
#1
RELA
Y
OUTPUT
#2
RELA
Y
OUTPUT
#3
SLIDE SWIT
CH
POSITION
1
AUXILIARY PUSH-BUTTON ‘1’
IS SELECTED
 1
  2
   3
2
AUXILIARY PUSH-BUTTON ‘2’
IS SELECTED
 1
 2
 3
3
AUXILIARY PUSH-BUTTON ‘3’
IS SELECTED
 1
 2
   3
ETSA48(x)RSP 3.4.13
REMOTE CONTROL PANEL
PSRNCTRL1, PSRN4CTRL1
PROGRAMMING MANUAL
* Set in “OTHER MODES” 6. Horn Ring Standby Tone
8 . Air Horn Button Output Channels
ON = In standby mode, Air Horn tone is
output on Spkr A & B. When Warning
Tone is Active, Warning Tone continues on
Spkr A & Air Horn Button Tone is output on
Spkr B
OFF = Air Horn Button Tone always
produced on Spkr A & B.
4. AUTO TONE IN LEVEL 3:
ON = Auto Tone in Level 3
OFF = Auto Tone Disabled