SONIQ MB200 User Manual
Page 3
3
4
• Be sure to install the batteries before unplugging the AC/DC adaptor.
• Be sure that the batteries are inserted correctly to avoid damage to the unit.
WARNINGS:
• Replace the batteries with new batteries If the playback is abnormal.
• Replace only with the same or equivalent type; danger of explosion may happen if batteries
are incorrectly replaced.
• When the unit is going to be left unplugged for a long time, remove the batteries to avoid
undue batteries discharge and unit damage from batteries leakage.
• Do not dispose of batteries in a fire, batteries may explode or leak.
• Do not mix old and new batteries. Do not mix ALKALINE, standard (CARBON-ZINC) or
rechargeable (NICKEL-CADMIUM) batteries.
CAUTION: When discarding batteries, environmental problems must be considered and
local rules or laws concerning the disposal of these batteries must be strictly followed.
Using the power cord with AC/DC adaptor
Connect the power cord from
DC IN 9V jack of the back of the unit to AC outlet.
CAUTIONS:
• Using an AC/DC adaptor that is not supplied
with the unit may damage the unit.
• The supplied the adaptor operates on AC
100V-240V~50/60Hz. Ensure the rated voltage
of the adaptor matches your local voltage
before usage.
• The supplied the adaptor is for use with this
unit only. Do not use it with other equipment.
• If you are not going to use the unit for a long
time, disconnect the adaptor from the wall
outlet.
• Whenever the adaptor is plugged into a
wall outlet, electricity is running through the
unit, even it is in standby mode.
POWER SUPPLY
LOCATION OF CONTROLS
1.
VOLUME + : To increase the volume.
2.
PAIR: For pairing feature use.
3.
VOLUME - : To decrease the volume.
4.
LINE IN jack: Ø3.5mm jack for external
audio sources.
5.
DC IN 9V jack:To connect to AC/DC adaptor.
6.
Slide Switch (OFF/ /LINE IN) : To slide
horizontally to select modes of LINE IN and
Bluetooth
®
, or turn off the unit.
7. (
LOCK OPEN):To guide user
to open or lock the batteies cover.
8.
Line In Indicator: To turn green when the
unit is on LINE IN mode.
9.
Bluetooth
®
Indicator: To turn blue when
the unit is on Bluetooth
®
mode.Blinking
blue: ready to pair. Solid blue: paired.
1
3
2
4
5
6
7
9
8
TABLE OF CONTENTS
Safety Precautions......................................................................................................................1
Important Safty Instructions.........................................................................................................2
Location of Controls...................................................................................................................3
Power Supply..............................................................................................................................4
Enjoying Audio via Bluetooth
®
.....................................................................................................5
Enjoying Audio via LINE IN jack................................................................................................6
Troubleshooting Guides.............................................................................................................6
Specification.............................................................................................................................6
AC/DC Adaptor....................................................................................................x 1
User Maunal...............................................................................................................x 1
ACCESSORIES
To AC outlet
AC/DC adaptor
(Supplied)
Using Batteries
To Install Batteries:
1. Open or lock the batteries cover as the
icons on its side and the direction of
arrow below.
2. Insert 6 X “AA” size batteries (not supplied)
as picture shown below.
To "DC IN 9V" jack