Tealth, Bulb installation canopy hatch installation, Installing the glass – Casablanca Fan Company STEALTH CIRCUIT BREAKER 32xxA User Manual

Page 7

TILT THE FAN TO

INSTALL LAST

CANOPY SCREw

BULB INSTALLATION

CANOPY HATCH INSTALLATION

CANOPY

LOCK

wASHER

CANOPY

SCREw

Step 6. Tuck the wires into the canopy with the wire nuts

pointed upwards, so that the white and black wires are on

opposite sides of the canopy and all wires are clear of the

canopy opening.
Step 7. Install canopy hatch with the last canopy screw

and lock washer. To do this, tilt the fan body away from the

hatch opening.

Step 9. Screw the 100-watt Halogen bulb into the socket.

Do not touch the glass bulb with your fingers–it is extremely

important that the glass be clean. If it is touched, or dirty,

clean carefully with a tissue. A dirty glass bulb will cause the

bulb to fail almost immediately.

INSTALLING THE GLASS

GLASS

HATCH

Step 8. Straighten the fan, then check to ensure that there

is no movement between the canopy and ceiling or Hang-Tru

ball and downrod.

Tip: Place the lock washer on the canopy screw,

and the screw through the hatch before tilting the

fan to install the hatch onto the canopy.

Step 10. Position the indentations in the

outer rim of the glass so that they line

up with the tabs on the inside surface of

the fan light fixture rim.

Step 11. Carefully lift the glass shade

up inside the light fixture as far as it

will go.

Step 12. Rotate the glass shade in a

clockwise direction until it falls into the

notch for each tab.

Step 13. Turn power back ON at the

circuit breaker or fusebox.

This completes the installation of the

fan.

imporTanT! When installing the halogen bulb, care-

fully cut off the end of the plastic sleeve the bulb

comes in and hold the bulb by the plastic sleeve to

screw it into the socket.

noTe: In compliance with US Federal Energy Regula-

tions, this ceiling fan contains a device that restricts

the light kit to a maximum of 190 watts. Exceeding

that limit or the marked limit on this product may

result in a fire hazard or improper operation.

INDENTATION

FOR TAB

NOTCH

FOR TAB

MODEL AND

SERIAL NUM-

BER PLATE

tealth

GLASS HOLDER

TABS

HALOGEN BULB

100 wATT MAX.