SONIQ AWM3201 - Manual (Page 2)

WARNING
• Do not begin the installation until you have read and understood the instructions
and warnings contained in this installation sheet. If you have any questions
regarding any of the instruction or warning, please contact your local distributor.
• This mounting bracket was designed to be installed and utilized ONLY as
specified in this manual. Improper installation of this product may cause damage
or serious injury.
• This product should only be installed by someone of good mechanical ability,
with basic building experiences and fully understanding of this manual.
• Make sure that the supporting surface will safely support the combined load of
the equipment and all attached hardware and components.
• Never exceed the maximum load capacity.
• If mounting to wood wall studs, make sure that mounting screws are anchored
into the center of the studs. Use of a stud finder is highly recommended.
• Always use an assistant or mechanical lifting equipment to safely lift and position
equipment.
• Tighten screws firmly, but do not over tighten. Over tightening can damage the
items, greatly reducing their holding power.
• This product intended for indoor use only. Using this product outdoors could
lead to product failure and personal injury.
NOTE: Read the entire instruction manual before you start installation and assembly. Component Checklist
IMPORTANT: Ensure that you have received all parts according to the component checklist prior to installing. If
any parts are missing or faulty, telephone your local distributor for a replacement.
Package M
Package W
ST6.3x55 (x6)
W-A
concrete anchor (x6)
W-B
D6 ø6.5xø24 washer (x6)
W-C
ø14xø6x10 (x4)
M-J
ø15xø8x15 (x4)
M-K
M4x14 (x4)
M-A
M6x14 (x4)
M-E
washer
M-I
(x4)
M4x25 (x4)
M-B
M5x25 (x4)
M-D
M6x25 (x4)
M-F
M8x30 (x4)
M-H
M5x14 (x4)
M-C
M8x15 (x4)
M-G
4mm allen key (x1)
M-L
wall template (x1)
C
articulated arm assembly (x1)
A
adapter bracket (x1)
B
- 1 - -2-