Rite-Ride 8632 - Manual

07-10 NAD-37750
WORK-RITE LOAD ASSISTS 1260 2
FACE PLATE 5641 2
SPACER RING 5709 2
CLAMP RING 5710 4
1/2" SPACER 0013 4
PARTS LIST
8632
INSTALLATION INSTRUCTIONS
Congratulations – your new Work-Rite load assists are quality products capable of
improving the handling and comfort of your vehicle while under load. As with all products,
proper installation is the key to obtaining all of the benefits your kit is capable of delivering.
Please take a few minutes to read through the instructions to identify the components and
learn where and how they are used. It is a good idea to start by comparing the parts in your
kit with the parts list below.
NOTE: IF ANY PARTS ARE MISSING FROM THE KIT,
PLEASE CALL 1-800-888-0650.
PLEASE DO NOT CALL OR RETURN THE KIT TO THE DEALER.
Be sure to take all applicable safety precautions during the installation of the kit. The
instructions listed in this brochure and the illustrations all show the left, or driver’s side of the
vehicle. To install the right side assembly simple follow the same procedures.
STEP 1 – PREPARE THE VEHICLE
With the vehicle on a solid, level surface chock the front wheels. Remove the negative
battery cable. Remove the jounce bumpers located under the frame rail, by prying them out
of the jounce bumper cup. The jounce bumpers will not be re-used with this kit but the bolts
will be reused.
STEP 2 – PREASSEMBLY
Select one Work-Rite load assist and one face plate for the kit. Attach the Work-Rite
to the face plate using the 3/8"-16 x 1" hex bolt, flat washer, and lock nut. See Figure “A”.
NOTE: An optional spacer may be installed to engage the Work-Rite sooner
when a load is applied. To install, place between the Work-Rite and the face plate.
If the spacers are installed, use the 3/8"-16 x 2" bolts instaed of the 3/8"-16 x 1"
bolts. There should be 1/4" to 3/8" between the Work-Rite and the jounce stop.
See Figure "B".
STEP 3 – INSTALLING THE ASSEMBLY ONTO THE VEHICLE
Select one spacer ring from your kit and place it around the jounce bumper cup. Place
the assembly against the bottom of the jounce bumper cup and align the holes in the face
plate with the holes in the spacer ring. Place the clamp rings on top of the space ring, aligning
the holes. Insert the 3/8"-16 x 1-1/2" flat head bolts into the tapered holes on the face plate
and secure to the clamp ring with the flange lock nuts. See Figures “A” & "B".
STEP 4 – FINISH UP
Remove the wheel chocks and reconnect the battery cable. Now you're finished and
ready to put your Work-Rite to use!
3/8"-16 X 1" HEX BOLT 2
3/8"-16 X 2" HEX BOLT 2
3/8"-16 X 1-1/2" FLAT HEAD BOLT 12
3/8"-16 FLANGE LOCK NUT 14
3/8" FLAT WASHERS 2