Rite-Ride 2475 - Manual (Page 4)

S
TEP
6 - C
HECK THE AIR SYSTEM
Once the inflation valves are installed, inflate the air helper springs to 70 psi and check the fittings for air leaks. Using a spray
bottle, apply a solution of soap and water to the fittings. If a leak is detected at a airline tubing connection then check to make
sure that the airline tube is cut as square as possible and that it is pushed completely into the fitting. The airline tubing can easily
be removed from the fittings by exhausting all the pressure in the air springs and then pushing the collar towards the body of
the fitting and then, with a gentle pull, remove the airline tubing. If a leak is detected where the air fitting screws into the spring,
screw the air fitting into the air spring until the leak stops. Reinflate the air springs and check for leaks as noted above.
This now completes the installation. Reattach the negative battery cable and remove the wheel chocks from the wheels. Before
proceeding, check once again to be sure you have proper clearance around the air springs. With a load on your vehicle and the
air helper springs inflated, you must have at least 1/2" clearance around the air springs. As a general rule, the air helper springs
will support approximately 50 lbs. of load for each psi of inflation pressure (per pair). For example, 50 psi of inflation pressure will
support a load of 2500 lbs. per pair of air helper springs. FOR BEST RIDE use only enough air pressure in the air helper springs
to level the vehicle when viewed from the side (front to rear). This amount will vary depending on the load, location of load,
condition of existing suspension and personal preference.
N
OTE
:
Too much air pressure in the air helper springs will result in a firmer ride, while too little air pressure will allow the air helper
spring to bottom out over rough conditions. Too little air pressure will not provide the improvement in handling that is possible.
TO PREVENT POSSIBLE DAMAGE MAINTAIN A MINIMUM OF 5 psi IN THE AIR HELPER SPRINGS AT ALL TIMES.
N
OTE
:
MIN PRESSURE 5 PSI
MAX PRESSURE (LOADED) 100 PSI
www.riderite.com