Wireless > wireless mac filter, Advanced configuration, Wireless mac filter – Cisco WRT310N User Manual
Page 17
Chapter 3
Advanced Configuration
16
Wireless-N Gigabit Router
IMPORTANT:
If you are using WEP encryption,
always remember that each device in your
wireless network MUST use the same WEP
encryption method and encryption key, or else
your wireless network will not function properly.
RADIUS Server
Enter the IP Address of the RADIUS
server.
RADIUS Port
Enter the port number of the RADIUS
server. The default value is 1812.
Shared Secret
Enter the key shared between the Router
and the server.
Encryption
Select a level of WEP encryption,
40/64 bits (10 hex digits) or 104/128 bits (26 hex digits).
The default is 40/64 bits (10 hex digits).
Passphrase
Enter a Passphrase to automatically generate
WEP keys. Then click Generate.
Key 1
If you did not enter a Passphrase, enter the WEP
key manually.
WEP
WEP is a basic encryption method, which is not as secure
as WPA.
Security Mode > WEP
Encryption
Select a level of WEP encryption,
40/64 bits (10 hex digits) or 104/128 bits (26 hex digits).
The default is 40/64 bits (10 hex digits).
Passphrase
Enter a Passphrase to automatically generate
WEP keys. Then click Generate.
Key 1
If you did not enter a Passphrase, enter the WEP
key manually.
Click Save Settings to apply your changes, or click Cancel
Changes to cancel your changes.
Wireless > Wireless MAC Filter
Wireless access can be filtered by using the MAC addresses of
the wireless devices transmitting within your network’s radius.
Wireless > Wireless MAC Filter
Wireless MAC Filter
Enabled/Disabled
To filter wireless users by MAC Address,
either permitting or blocking access, select Enabled. If you
do not wish to filter users by MAC Address, keep the default
setting, Disabled.
Access Restriction
Prevent
Select this to block wireless access by MAC
Address. This option is selected by default.
Permit
Select this to allow wireless access by MAC
Address. This option is not selected by default.
MAC Address Filter List
Wireless Client List
Click this to open the Wireless Client
List screen.
Wireless Client List