Rite-Ride 4141 User Manual
Page 3
FIGURE “F”
FIGURE “G”
NYLON
TIES
AIR LINE
AIR LINE TO
INFLATION VALVE
Cut the excess air line tubing so that it will fit eas-
ily into the inflation valve, making sure the end is cut
squarely (a "saw" cut with a sharp knife is preferred).
Push the end of the tubing into the inflation valve as far
as possible.
STEP 9—INFLATE AND TEST
Inflate the air springs to recommended maximum oper-
ating pressure (see page 1 for operating pressures). With
a soap and water solution, check for air leaks around
the fittings and valve core. We recommend inflating and
deflating in small increments to find the ideal riding con-
dition for your vehicle.
STEP 10—COMPLETION
Installation is now complete. Replace the wheels and
torque the lug nuts to the manufacturer's specification.
Raise the vehicle and remove the jack stands and lower
the vehicle to the ground. Re-attach the positive battery
cable.
AIR LINE
PUSH-TO-CONNECT
INFLATION VALVE
FLAT WASHER
HEX NUT
VALVE CAP
BODY OF
VEHICLE
FIGURE “H”