Connections, Important – Revel C30 User Manual
Page 14
Figure 14. Wire gauge versus
maximum wire run (with a
maximum loop resistance of
0.07 ohms) for less than 0.2 dB
response error.
NOTE: “Loop resistance” is the
DC resistance measured at one
end of a loudspeaker cable, with
the other ends shorted together.
CONNECTIONS
For best results, please read the following points before connecting
the REVEL PERFORMA C30 loudspeakers:
• Use high-quality speaker cable with a maximum total loop resis-
tance (for each wire run) of 0.07 ohms or less. Use the chart in
Figure 14 below to determine the maximum wire gauge.
A high loop resistance will result in mis-termination of the
filter networks, and serious degradation of sound quality.
Use high-quality connectors on the loudspeaker cables.
Consult your Revel dealer as to specific recommendations for
your application.
• Turn off all audio system power before making any connections.
• Read the owner’s manuals that were included with your audio
components to confirm their connection procedures.
• Verify correct polarities (i.e., + to + and - to -) when making
connections, as shown in Figure 15 on the next page. Failure to
do so will cause poor imaging and diminished bass response.
REVEL PERFORMA C30
Owner’s Manual
14
W
IRE
G
AUGE
(AWG) L
ENGTH
(
FEET
)
L
ENGTH
(
METERS
)
6
87
27
7
69
21
8
58
18
9
43
13
10
34
10
11
27
8
12
22
7
13
17
5
14
14
4
15
11
3
16
9
3
17
7
2
18
5
2
IMPORTANT