Revel F12 - Manual (Page 12)

12
REVEL Concerta F12
Owner’s Manual
To install the spikes:
1. Place the F12 on its side on a soft towel
or carpeted floor.
2. Rotate the spike clockwise into the
threaded insert in the center of a rub-
ber foot, round end first, as shown on
the right side of Figure 7 (above).
3. Repeat step 2 for the remaining three
spikes. Make sure to thread each spike
fully to achieve a level balance.
4. When all four spikes have been
installed, stand the F12 in the upright
position.
5. Repeat these steps to install the spikes
on the other F12.
CAUTION
Floor-standing loudspeakers such as the
F12 have a high center of gravity, which
may cause them to fall if tipped or
improperly positioned.To avoid this,
anchor the loudspeaker to the floor
and/or wall using the same procedures
and hardware used to anchor bookcases,
wall units, and other furniture. Harman
Specialty Group assumes no responsibility
for improper selection and installation
of hardware or for any personal injuries
or product damages resulting from
improper installation or a fallen loud-
speaker.
(Threaded into
Center of Foot)
When shipped, the rubber
feet are attached as shown
here for loudspeaker
placement on tile or hardwood
floors. The spikes should be
inserted as shown here
for loudspeaker placement on
carpeted floors.
Figure 7: Adjustable Spike feet