Revel W990 - Manual (Page 5)

5 In-Wall Architectural Loudspeaker
Instruction Manual
5.1-Channel Surround Speaker Placement
• In a 5.1-channel system, the surround left and surround right
loudspeakers should be located to the sides of the main listening
area, 5 ft – 7 ft (1.5m – 2.1m) from the floor.
Approx.10°
Surround Right Surround Left
Front Left Front Right Center
7.1-Channel Surround Speaker Placement
• In a 7.1-channel system, the surround left and surround right
loudspeakers should be located directly to the sides of the main
listening area, 5 ft – 7 ft (1.5m – 2.1m) from the floor.
• In a 7.1-channel system, the surround back left and surround back
right loudspeakers should be located on the rear wall, 3 ft – 6 ft
(0.9m – 1.8m) apart and at 5 ft – 7 ft (1.5m – 2.1m) from the floor.
3' – 6'
(0.9m – 1.8m)
Surround
Right
Surround
Left
Surround
Back Left
Surround
Back Right
Front Left Front Right Center
INStAllAtIoN INStRuctIoNS
Revel architectural speakers are the most easily installed in-wall
loudspeakers on the market. However, if you are unable to understand
and follow the instructions in this manual clearly and fully, or if you
are unsure of your ability to install these loudspeakers properly, please
contact your dealer or a qualified installer.
WARNING: HARMAN International assumes
no responsibility for improper installation of
hardware or for any personal injuries or product
damages resulting from improper installation or
a fallen loudspeaker.
coNNectINg to tHe AmplIfIeR
CAUTION: REMOVE POWER
You must connect the speaker wires before the speaker is fully
installed. To protect the audio system from damage and yourself
from injury through accidental electrical shorting and surges
during installation, turn all audio system power OFF before
beginning the speaker installation.
Speaker Wire
Use high-quality speaker wire to obtain the best performance from your
Revel in-wall speakers.
• For wire lengths of less than 50 ft (15m), use at least 16-gauge
speaker wire.
• For wire lengths between 50 ft and 100 ft (15m – 30m), use at least
12-gauge speaker wire.
• For wire lengths of greater than 100 ft (30m), use at least 10-gauge
speaker wire.
Note: All speaker wires must comply with all local building and
safety codes for use in in-wall applications.