Reloop RMP-1 SCRATCH LTD. - Manual (Page 27)

The player saves the samples set in this manner until they are overwritten by
new ones or the device is switched off. Even when changing the track or the CD,
the saved samples are stored. The button of an assigned Sample bank is always
lit red if the assigned (= sample's own) CD has been inserted. If a different CD is
inserted (= non-sample) the respective button lights up in blue. The button of the
last assigned sample bank also flashes in the respective colour. A sample bank is
overwritten when new samples are recorded. The four sample banks are also Hot
Cue Point memories. When pressing the button of a sample bank without
previously having activated the Memory button or the Sample button, the Player
returns while in Play mode as well as in Pause mode to the beginning of the
respective sample. This function is only available for CDs of samples or with
sample banks that are illuminated in red.
NOTES:
• If you wish to lastingly save the set Cue Points / Samples, press the
Memory button -16- for two seconds. The display reads "Saving". This
means that the Cue Points / Samples of the CD's own sample will be
maintained even after switching the device off. Saving the four Cue
Points / Samples is possible for up to 500 CDs. To prompt the saved Cue
Points / Samples of a CD again, press the Memory button -16- BEFORE
inserting the CD. The display reads "Recall". Now insert the CD and the
previously stored Cue Points/Samples are automatically loaded. The
respective storage banks flash red and are ready for play.
• To completely delete the Cue Point / Sample Bank memory, first switch
off the device with the ON/OFF switch -31-. Then turn the Search Wheel
-5- counter-clockwise until the point of resistance and hold it in this
position. Switch the device on with the ON/OFF switch. Release the
Search Wheel again as soon as the display reads "Clear all".
TROUBLESHOOTING
If your Reloop RMP-1 scratch is experiencing any difficulties please check the
following table for malfunction symptoms and take the corrective measures
proposed in the table.
27
ENGLISH
Possible cause
Poor mains plug
connection.
The CD is upside in the
tray down or is soiled.
Output cable is wrong
or not correctly
connected, wrong
amplifier or mixing
console operation.
The CD player is
continuously exposed to
vibrations and shocks
for longer than 30
seconds.
Loose cable
connections.
Symptoms
No power when
activating the power
ON/OFF switch.
The CD replay does not
start.
No sound.
CD skips.
Humming sound.
Remedy
Check mains plug
connection
Place CD in tray with
label facing up; clean
CD.
Check connections of
output cables and
settings on amplifier or
mixing console.
Install the equipment at
another location.
Check sound plugs.
RMP1_scratch_IM.qxp 04.03.2008 16:39 Uhr Seite 27