Reloop RMP-1 SCRATCH LTD. - Manual (Page 26)

ATTENTION!
Damage caused by independently switching to the wrong voltage leads to a
waiver of any guarantee or warranty claims.
29. Cinch output hub
Connect the output hubs -29- with the Line IN hubs of your mixing console
or amplifier.
30. Digital output hub
Connect the digital output hub -30- to a device that features a digital input,
for example a CD burner, MD recorder, digital mixer or audio card.
31. On/Off Switch
Switch your device on or off with this switch.
32. Line cord connection hub
Connect the connection hub -32- with a line cord and insert it into an outlet.
SAMPLING
This chapter details the possibilities and settings of the mighty on-board sampler
of your device.
A loop is the permanent repetition of a sequence between a chosen loop starting
point and a chosen loop end point. Select a loop starting point by pressing the
Loop IN button -12-. Select the Loop End point by pressing the Loop OUT button
-13-. The player goes automatically into Loop mode and the Reloop display
flashes. The sequence thus chosen is seamlessly re-played until the Loop OUT
button - 13- is pressed a second time. The player seamlessly goes into Play mode.
To prompt the last played loop against, press the Reloop button -14-. The player
goes automatically into Loop mode.
NOTES:
• The player saves this loop for the current track only. When changing to
a different track, no loop is stored.
• The currently saved Loop starting point (set with the Loop IN button
-12-) is also the current Cue Point. When saving a new Cue Point, after
saving a Loop and exiting the Loop mode, this overwrites the current
starting point. The re-loop display goes off and no loop is saved anymore.
You have four sample banks available, each of 5 seconds. To record a sample, set
a loop as described above using the Loop IN and Loop OUT buttons. Then press
the Memory button -16- and then one of the four memory buttons -15- The loop
thus set is now saved in the chosen sample bank and the Memory button goes
off. To play a sample, first press the Sampler button -17-. Then press the desired
one of the four memory buttons. The Sampler plays the sample from the chosen
bank in an endless loop (Endless mode). Press the Sample button once again to
play the sample once only (One Shot mode). To end playing the sample, press the
Sample button again. The light goes off.
NOTE:
• When in Sampler mode, playing a sampler is activated independently
from CD play. In Play mode the current track can also be heard as the
sample. In Cue and Pause mode, only the sample can be heard.
26
ENGLISH
RMP1_scratch_IM.qxp 04.03.2008 16:39 Uhr Seite 26