Reloop TERMINAL MIX 8 - Quick Start Guides - Manual (Page 5)

ENGLISH 5
TERMINAL MIX 8 QUICK START GUIDE
VERSION 1.1
SLICER
HOT CUE MODE LOOP MODE
Slicer Mode: A specified range (or domain) is
divided into eight equal sections, and these eight
sliced sections are assigned to the respective
performance pads.
Pressing SLICER once for the first mode, is a
shifting Slicer Domain.
(Continuous slicer mode / White LED‘s)
Pressing SLICER twice, for the second mode is a
fixed Slicer Domain or “loop”.
(Looped slicer mode / Red LED‘s)
To adjust PARAM 1 + PARAM 2 (Domain size +
Quantize adjust) hold SHIFT + Lit drumpads.
Green + Blue for adjusting parameters UP + DOWN
Press loop mode once to activate loop roll mode.
In this mode you can trigger loop rolls in different
lengths.
Press loop mode twice to activate manual loop
mode:
ROLL
Holding SHIFT + pushing and turning
the loop encoder will launch a drum
roll effect
Hit to save and launch up to 8 CUE points per track
Press HOT CUE mode twice to launch CUE ROLL
mode
Note: CUE pads will light as defined in the software
DUAL MODE
Pressing two modes simultaneously will split the
drum pads into two layers. The LEDs will
correspond to the active mode - (Top 4 / Bottom 4)
COMBO MODES:
SAMPLE /CUE SAMPLE/LOOP CUE/LOOP
PERFORMANCE MODE
RELOOP
IN OUT ACTV DOWN
UP SAVE