Reloop NEON - Serato Quickstart Guide - Manual (Page 7)

DJ-FX
The DJ-FX in Serato DJ are powered by iZotope™. Click the FX tab
to open the FX panel. Select either 1, 2, 3, 4 or M to assign the selected effect bank
to a deck or Master Output.
There are two available modes in the DJ-FX. Single FX Mode allows you to
select one effect per FX bank, and has multiple parameters that can be adjusted.
Multi FX Mode allows you to select up to three effects per FX bank, and adjust
only one parameter, the FX Depth. The same effects available in Single FX mode
are available in Multi FX mode, as well some additional presets.
You can select between the two FX modes by clicking either the Single FX mode
button or Multi FX mode button in the software.
On the Reloop NEON, press SAMPLER mode twice to enable PAD FX mode.
Pads are velocity sensive when controlling FX or adjusting FX parameters.
NEON Control Multi FX Mode Single FX Mode Shift
Pads 1-3 FX Unit 1 Effect
On/Off. Velocity
Sensitive.
FX Unit 1 Effect
On/Off/Parameter
Adjust.
Effect Select
FX Unit 1
Pad 4 Adjust Beats value
left Adjust Beats value
left N/A
Pads 5-7 FX Unit 2 Effect
On/Off. Velocity
Sensitive.
FX Unit 1 Effect
On/Off/Parameter
Adjust.
Effect Select
FX Unit 2
Pad 8 Adjust Beats value
right Adjust Slot 1
FX Parameter N/A
Serato Flip
Flip is an Expansion Pack for Serato DJ. Flip controls are only available
once the Flip expansion pack has been purchased and activated. The
expansion pack can be purchased in-app through the Serato DJ Online
window, or online at
http://serato.com/accessories
In HOT CUE performance pad mode SHIFT + BANK/DECK buttons are used
to record, trigger and loop Flips.
Press
Hot Cue mode twice to enter Flip performance pad mode. Pressing
pads 1-6 in will trigger saved Flips, pressing SHIFT + pads 1-6 will turn
saved Flips on/off. Pressing an empty Flip slot will save any active Flip to
that slot.
NEON Control Flip function
SHIFT + 1 (REC) Starts the recording of a new Flip
SHIFT + 2 (ON) Starts the current Flip / re-trigger Flip
SHIFT + 3 (LOOP) Turns Flip Loop on/off
SHIFT + 4 (START) Turns current Flip On/Off