RCBS RASS - Manual (Page 4)

4
UNPACKING
Open the box to remove, identify and layout the parts for assembly. To better understand these instructions, please refer to the parts
drawings found at the back of this manual.
ASSEMBLY
Place the steel Shaft Hub assembly in the middle of your workspace.
Using an 18mm or adjustable wrench (not included), remove the lower M12x1.75x60mm Hex Bolt and M12x1.75 Acorn Nut from the
Leg Assembly. Keeping the Leg Bushings in place, carefully slide the Leg assembly into the slot in the Hub. Align the holes and
reinstall the Hex bolt and Acorn Nut. Repeat the process for the other three Leg assemblies (see Photo 1).
Photo 1 Photo 2 Photo 3
RASS Bench Assembly - Shipping
Item # Part # Quantity Description
1 180112 1 Ammo Tray
2 180127 1 Cinch Strap
3 CENTER_POST_ASSY 1 Rifle Rest Assembly
4 FRONT_CRADLE_ASSY 1 Front Rest Assembly
5 LEG_ASSY 4 Leg Assembly
6 REAR_CRADLE_ASSY 1 Rear Cradle Assembly
7 RIFLE_PLATFORM_ASSY 1 Rifle Rest Assembly
8 SEAT_ASSY 1 Seat Sub-Assembly
9 SEAT_BAR_ASSY 1 Seat Unit Assembly
10 SHAFT_HUB_ASSY 1 Shaft / Hub Assembly
1
3
4
5
6
7
8
9
10
2
4X