RCBS Hand Priming Tool - Manual (Page 2)

IMPORTANT
Before using the RCBS Hand Priming Tool read this instruction sheet carefully to
learn how to safely operate the tool. Failure to properly operate this product can result in
severe personal injury and/or equipment damage. This instruction sheet contains specific
safety and operating information. It should be considered a permanent part of your reload-
ing equipment and remain with the equipment at all times for easy reference. Call us if you
have any questions at any time while assembling or operating this tool.
SAFETY
Reloading is an enjoyable and rewarding hobby that is easily conducted with safety. But
carelessness or negligence can make reloading hazardous. This product has been designed
from the beginning with the user’s safety in mind.
As with any reloading operation, some safety rules must be followed. By observing
these few rules, the chance of a hazardous occurrence causing damage or injury becomes
extremely remote.
GENERAL
• Use the reloading equipment as the manufacturer recommends.
• Study the instructions carefully and become thoroughly familiar with the
operation of the product. Don’t take short cuts.
• Observe “good housekeeping” in the reloading area. Keep tools and com-
ponents neat, clean and orderly. Promptly and completely clean
up primer and powder spills.
• Reload only when you can give your undivided attention. Do not reload
when fatigued or ill. Develop a reloading routine to avoid mistakes. Avoid
haste - load at a leisurely pace.
• Always wear adequate eye protection. You assume unnecessary risk when
reloading without wearing safety glasses
.
LOADING DATA
• Use only laboratory tested reloading data. We highly recommend the
use of the SPEER Reloading Manual.
• OBSERVE ALL WARNINGS ABOUT THE USE OF MAXIMUM LISTED
LOADS.
▲
!