RCBS The Grand Conversion Unit User Manual
Page 5
4
20. Reinstall charge bar with appropriate shot and powder
bushing.
21. Reconnect charge bar to linkage with locking pin.
22. Reinstall hoppers. Section titled INSTALL POWDER AND
SHOT HOPPERS.
23. Fill POWDER and SHOT hoppers.
24. You’re ready to load (note: If using two piece 12 gauge
Winchester AA red or gray hulls, install the longer lower
shot tube at station #7, this insures proper wad seating
pressure and prevents ‘crushing’ of the hull during the
crimp process).
16. Insure that the three column supports are secured tightly.
17. Install proper toolhead and reinstall the three column
screws.
18. Position and tighten case eject assembly in accordance
with section titled COMPONENT ADJUSTMENT
SECTION, case eject adjustment.
19. Reattach lower push rod to upper push rod. (Note: The
lower push rod will “bottom” out into the upper push rod.
The 1/4-28 nut should be at the bottom of the threads on
lower push rod during re-assembly.) (See photo 6)
6