La Cornue AlberTine 36 - Manual (Page 24)

INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
22
Moving the Range
 The range is very heavy. Take great care.

On no account try and move the range while it is
plugged into the electricity or gas supply.
We recommend two people maneuver the range. Make sure
that the floor covering is firmly attached, or removed to
prevent it being disturbed when moving the range around.
To help you, there are two leveling rollers at the back, and
two screw-down leveling feet at the front.
Remove the polystyrene base pack. From the front, tilt the
range backwards and remove the front half of the polystyrene
base (Fig.7-4).
Repeat from the back and remove the rear half of the
polystyrene base.
Removing the door
Remove the oven door as follows: open the door fully. Swivel
the locking ‘U’ clips forward to the locking position (Fig.6-4).
To remove the oven door, grip the sides of the door, lift
upwards and then slide the door forwards (Fig.6-5) and
remove.
Removing the storage drawer
Pull the drawer right out.
Push the ends of the plastic clips – down of the left-hand side,
up on the right-hand side – to release the catches holding the
drawer to the side rails (Fig.6-6). At the same time pull the
drawer forwards and away from the side rails.
For safety’s sake push the drawer rails back out of the way.
Put the drawer somewhere safe – do not replace it until you
have completed the installation, you will need access to the
area behind the drawer.
Lowering the Two Rear Rollers
To adjust the height of the rear of the range, first fit a 13 mm
spanner or socket wrench onto the hexagonal adjusting
nut (Fig.6-7). Rotate the nut – clockwise to raise – counter-
clockwise to lower.
Make 10 complete (360°) turns clockwise. Make sure you
lower BOTH REAR ROLLERS.
Completing the Move
Unfold the rear edge of the cardboard base tray. Get a good
grip on the top of the oven cavity panel as you move the
oven. Carefully push the range backwards off the cardboard
base. Remove the base tray.
Position the range close to its final position, leaving just
enough space to get behind it (Fig.6-8).
Do not replace the storage drawer yet.
IMPORTANT: Remove all tape and packaging. Make sure
the burner heads are properly seated and level. Take the
accessory pack out of the oven. Check to be sure that no
range parts have come loose during shipping.
Fig.6-6
ArtNo.281-0017 - Removing the door
Fig.6-4
ArtNo.325-0002 - BI oven removing the door
Fig.6-5
Fig.6-7
Fig.6-8