Klimaire KTHM015-E5H2 PTAC Service Manual - Manual (Page 7)

5
 2. Function and control panel.
KTHM009-E3C2 KTHM012-E3C2 KTHM015-E5C2
KTHM009-E3H2 KTHM012-E3H2 KTHM015-E5C2
The controls featured in this manual are representative of many available models. Your model
may offer slightly different features.
POWER
- Press the POWER button to turn the unit on or off.
When the unit is on, the power indicator light will be green.When the unit is off, the light will go out.
MODE
- Push this button to cycle through the modes from COOL-HEAT-FAN-COOL.The green indicator
light beside the "MODE" option will illuminate, identifying the mode selected.
- COOL:The range of set temperature is 17℃/62℉~30℃/86℉.Cooling begins automatically when the
room temperature is above the set point,and stops when the room temperature is 2℃(4℉) below the
set point. But the compressor will run 5 minutes at least in COOL mode before stoping. The fan runs
in continuous mode.
- HEAT:The range of set temperature is 17OC/62OF ~29OC/84OF.For heat pump models,the unit can
alternate to run between in reverse cycle heat mode and electric heater mode according to the
difference between the setting temperature and the room temperature.The fan motor cycles on and
off with the compressor and electric heater.
NOTE: The reverse cycle and electric heater can not be run at the same time.
202021890236