Kino Flo Multi Flo (12 Lamp) User Manual

Page 3

Connect cables, lamps or fixtures according to the flow
charts on pages 4-6.

Any theatrical lighting board with DMX 512
protocol can be used to individually turn
on/off 12 lamps per Multi-Flo.

Multi-Flos can be jumpered using the IN
and OUT ports. As many as 100 Multi-Flos
can be jumpered on one chain as long as
the DMX cable run remains under 1000
feet or 40 x 25ft DMX cables.

Note: Do Not power the Multi-Flo through
a dimmer rack

The DMX Terminate Switch must be set to open
( O ) on Multi-Flos within the DMX chain.

Set to closed ( I ) when the Multi-Flo is the last
DMX control device in the chain.

DMX Address

Push the tabs above or below the number
window to set the address. ( Valid addresses
range from 001 to 512.) The yellow light
above the address block will illuminate if a
DMX signal is present.

After the DMX address is entered, the Multi-
Flo automatically assigns the next 11
addresses to lamps 2 -12. For the sake of
simplification it is advisable to select address
sequences such as 1, 20, 40, 60, 80 and so
on.

Note: As soon as a DMX signal is present
the LED Lights on the switches turn amber
and the manual control is disabled.

For more DMX information go to:

www.kinoflo.com