JK Audio Voice Path - Manual (Page 8)

8
FAQ’s
?
I have a Voice Path connected between my tele-
phone and computer. I can record conversations
to my sound card but cannot send audio (from
the PC) down the phone line. What should I do?
!
First make sure the Voice Path cable marked "Input
from PC" is connected to the line output or speaker
output of your sound card. This is usually where you
connect your PC speakers. Next, make sure your
computer volume (software) is at an acceptable
level.
Now follow these steps:
• Complete a call to a friend who can listen and evalu-
ate the signal. You will be able to hear their com-
ments during the call.
• Set the gray pushbutton on the Voice Path to the in
position. This disables the handset microphone and
enables the audio input.
• Play an audio file on your computer. It should be
long enough to complete this test (or select "loop
playback" from your software).
Next, switch between the 3 handset type positions on
the A-B-C selector switch on the back of the Voice Path.
Select the position with the best audio quality (best does
not necessarily mean loudest!). Then adjust the sound
card output level using your software.