JK Audio RemoteMix C+ - Manual (Page 4)

4
Send Side (To Phone Line)
There are separate volume controls for the two XLR
microphone inputs and the RCA line input (To Phone Line)
jack. You can use all three inputs at the same time. Mic 1
also has a Mic/Line
level selector switch
which lowers the gain
on the Mic 1 XLR
jack by 30 dB to
allow a balanced line
level input.
Receive Side (From Phone Line)
The receive side has separate controls for headphone output
level and line output level. The Line Out control adjusts the
signal going out the RCA and XLR jacks marked From
Phone Line. This is a mix of both sides of the telephone call.
Headphones
The built-in headphone amplifier is strong enough to power
two pair of headphones or a small desktop speaker. The left
and right channels contain the same mono signal, but are
powered by separate amplifier channels. These jacks will
drive either two 1/4” stereo plugs or two 1/4" mono plugs.
Handset Jack
The handset jack on the side
of RemoteMix C+ allows you
to plug in a telephone handset
and quickly set up a call before
you connect your microphones
and headphones. The handset
m i c r o p h o n e v o l u m e i s
adjusted using the Line In knob. The earpiece volume is
adjusted using the Headphone level knob. All telephone
handsets are different, so if yours is not compatible, try an
AT&T, Sony, or Radio Shack residential phone handset.
Operation