JK Audio RemoteMix C+ - Manual (Page 10)

10
FCC Part 15 Compliance
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
Changes or modifications not expressly approved by JK Audio can void
the user's authority to operate the equipment.
Inputs:
Unbalanced: Connector RCA phono jack
Input Impedance 50 k ohms
Level 250 mV RMS
Microphone: Connector (2) Female XLRs
Input Impedance 1000 ohms
Mic/Line: Line switch on Mic 1 -30 dB
Handset: Modular 4pin/4wire handset jack
Electret /dynamic microphone bias.
Outputs:
Unbalanced: Connector RCA phono jack
Output Impedance 50 ohms
Level 250 mV RMS
Balanced: Connector Male XLR
Output Impedance 200 ohms
Level 500 mV RMS
Headphone: Connector 1/4" stereo jacks
Output Impedance 8 ohms
Power 1 watt per channel
Phone Line: Connector RJ-11C
Isolation 1500 volts
Ringer (REN) 1.2B
Keypad: DTMF (Dual Tone Multi-Frequency) or
Pulse Dialing
Specifications