JK Audio Interloop - Manual (Page 14)

8
3. On your device, find and select
the option to set up a connection.
When the cell phone has found the
new device, select from the list the
device ID of "JKINTxxxx" where:
xxxx = last four digits of the serial
number.
4. If asked for a pin, enter "0000".
5. When bonding is complete, the blue
LED will flash at a rate of 2 secs
off, 1 sec on (2 secs off, 4 secs
on for HD Voice). Once Interloop
has been added to your cell phone,
subsequent connections can be
made more quickly from Idle Mode.
Pairing to a Cell Phone with
Bluetooth Wireless Technology
When you're first connecting to a
new device, you should be in an
environment with no other Bluetooth
wireless technology enabled devices
within range that might also be in
Pairing Mode.
1. Starting with the Power switch Off,
set the Phone/Headset switch to the
Phone position.
2. Press and hold the Pair button
on the Interloop while turning the
Power switch On. Hold the Pair
Button for 5 full seconds. After you
release the button, the blue LED
should flash rapidly if Interloop is in
Pairing Mode.
Bluetooth Wireless Technology
Interloop Wired/Wireless Intercom Belt Pack