JK Audio innkeeper 1x/rx - Manual (Page 5)

12
? Does the innkeeper 1x/1rx send a burst or beep down the
phone line at the beginning of each call like our current
hybrid?
! No. Innkeeper 1x uses the actual transmit signal to evaluate the
phone line and tune its algorithm. As you begin to speak, inn-
keeper 1x is hard at work canceling your voice from the Caller
Output jack. Within milliseconds your voice is reduced into the
noise floor.
? Will your innkeeper 1x/1rx provide phantom power for my
condenser microphone?
! No, our devices will not provide phantom power. If you plan to
connect your microphone directly to an innkeeper 1x, you
should use a dynamic mic.
? Are there more ASCII commands I can send through the
serial cable or can I add my own?
! The complete list of currently acceptable commands is listed
on page 10.
? Where is the software to control the serial port?
! There is no software provided with the innkeeper 1x/1rx. You
will provide your own terminal emulator, such as Hyper-
Terminal.
FAQs
5
Connection—Mix-Minus Setup
Number of mics
depends on mixer
Caller to any line
level input on mixer Aux Send on mixer to Send 1,
Mic/Line button out (Line)
Use Main Outputs,
USB or Firewire
connectors to
send audio to
recording device
or broadcasting
equipment inputs
For whichever input channel you have the Caller connected to, turn the
corresponding Aux control to minimum (usually hard left). All other Aux
controls should be set for what you want to send to the phone line. Each
Aux Send bus is completely separate from all other outputs, so these Aux
controls will not affect what is heard on the Main outputs or on any other
Aux buses. This Aux Send bus should be pre-fader, so you can use the
fader controls to set the levels of each channel to the main output.
Auxiliary telephone optional.
Used to dial out to set up calls.