JK Audio BSET-HS1 - Manual (Page 5)

5
Pairing Your Headset
1. Enable the Bluetooth wireless
technology feature on your
phone or other device.
2. Put the headset in Pairing Mode.
First make sure the headset is
switched off, press and HOlD the
Answer Button for 4-5 seconds
until the lED flashes red and
green.
3. Perform a search for enabled
devices on your phone or
computer.
4. Connect to BSET-HS1 when
found. The PIn code is 0000.
4
BSET-HS1 Wireless Headset Using the Headset
Pairing Your Headset Using the Headset
Answer a Call
Press the Answer Button.
Make a Call
Dial the number on the mobile phone
and press the Answer Button.
End a Call
Press the Answer Button, or end the
call on the mobile phone.
Mute
Press and release the Mute Button.
Press again to resume the call.
Voice Dialing
Briefly press the Answer Button
activate Voice Dialing.
In general, voice dial must be activated
on your phone before you can use it. For
more information on voice dialing and voice
commands, refer to your phone’s user
guide.
last number Re-dial
Press and hold the Answer Button
for 2-3 seconds. The phone number
will be listed on the phone.
The pairing mode is active for 3 minutes.
After that, the headset will enter
stand-by mode.
Note: Before using the headset, it must
be paired and connected to another
device equipped with Bluetooth wireless
technology. For specific instructions,
check the user's guide for your phone.
Note: Your phone or alternate device
may not support all features or may
behave differently.