JK Audio BluePack - Manual (Page 19)

FAQs
13
FAQs
Why is the peak LED still red
after I turned down the mic
volume level?
The microphone and Aux Send are
a combined input. If you see this red
LED flashing, you should decrease
the and/or input
levels until the combined input is no
longer clipping.
My BluePack won’t pair with
my cell phone. Why won’t it
accept the PIN?
If this is the first time you have paired
the BluePack with this cell phone,
make certain you are in Pairing Mode
and not Idle Mode. You must hold
the in for approximately 6
seconds to reach Pairing Mode the
first time you connect.
Can I have full duplex stereo
conversations if my stereo
headset uses A2DP?
No, the A2DP profile is only used for
stereo music streaming. Full duplex
conversations will be in mono.