JK Audio BlueDriver-F3 - Manual (Page 6)

2
Mode Switch
In the Bluetooth world, a Master
device, such as a wireless phone,
computer, or music player, is
connected to a Headset device.
Before you turn the BlueDriver on,
be sure to set the
Switch> to the correct position. If you
change that switch while the unit is
on, you will need to power the unit off,
then power the unit back on before the
change takes effect.
Select if you will be using
your BlueDriver with a Bluetooth
enabled headset or any device that
emulates a headset. Select
if you will be using your BlueDriver
with a cell phone or other master
device. See page 13 for more
information on Bluetooth profiles for
different wireless applications.
Mic Trim
A small flat blade screwdriver can be
used to adjust the pot
on the back of the unit. This adjusts
the level of the audio coming from
the microphone as it is sent to the
Bluetooth wireless technology enabled
device and to the recording output.
Recording Output
A 3.5 mm stereo output jack contains
a mic level signal suitable for
recording, with the clean mic signal
on the left channel and the Bluetooth
wireless technology return audio on
the right.
Power Rec
Getting To Know your BlueDriver-F3