HCO MB600 User Manual

Page 21

Page | 20

Sending a picture takes 5s-60s depending on the network signal strength. SMTP
generally takes longer time than MMS.

USING CAMERA ONLY TO SETUP CELLULAR SETTINGS

Set SEND MODE: Off, Instant, Customized, or Daily Report

Set SEND VIA: MMS or smtp

Set SEND TO: Phone, Email, or Both

Set NETWORK SETUP:
NOTE: Push the OK button to select each letter/number. The disk icon is for saving
settings; the large left arrow button is for deleting, and the small right arrow is to
return to previous menu.

Phone: enter phone number using arrows, press OK to save.

Email: enter email address using arrows, press OK to save.

Cellular Provider: select your provider from the menu. If your provider is
not present, you will need to use the „Download Tool‟ explained
previously.

Set PHOTO QUALITY: Normal or High

2G/3G MODE:
2Gmode uses GSM cellular frequencies. 3G mode uses HPSA/+ cellular
frequencies.

NOTE: If the network does not support GSM, user should switch to 3G mode only.

Set REMOTE CONTROL: Disable, 24 Hour or Once.

NOTE: Explanations of the above settings are explained in greater detail previously in
manual (pg. 10

– 19).

Additional Notes:



Be sure your SIM card works on the GSM or HSPA service. This device supports
four bands: 850MHz, 900MHz, 1800MHz and 1900MHz.



If sending photos by MMS, you will want an MMS picture messaging plan. If
sending photos by SMTP account, you will want a Data plan on the SIM card.



There is a max limit on the number of pictures sent daily to your phone. Please
check the MAX number in "Instant" and "Custom" modes toset the desired number
of pictures.