Gossen Sixtomat flash - Manual (Page 11)

GOSSEN Foto- und Lichtmeßtechnik GmbH 11
3.2.2 Multiple flash
Occasionally the light output from a single flash
may not be sufficient to enable you to work at the
aperture desired. When this happens, simply
push the top value button until the desired
f/number appears in the display.
The digital shutter speed display disappears, to
be replaced by information on the number of flas-
hes that have to be fired for the desired f-stop
(e.g.: F4 = 4 flashes).
The SIXTOMAT flash will calculate up to a
maximum of 10 flash sequences.
3.2.3 Shutter priority mode –
Continuous light measurement
– Select with the function buttons (the last
stored value appears on the display)
– Adjust the desired shutter speed with the va-
lue buttons
– Measure by pressing the meas. button
– The measured aperture appears
on the left-hand digital display
(accuracy: 1/10 stops), also as a rounded
mark in the analog aperture scale
– Select alternative aperture/shutter speed-
combinations with the value buttons
t
M