Garden Sun Heater HS-SS Commercial Square - Manual (Page 11)

11
ALIGN
MOUNTING
HOLES
SIDE
VIEW
FOR SCREWS
MOUNTING HOLE
COMMERCIAL OUTDOOR HEATER
Step 7
Turn the hood upside down on your cardboard work surface. Place the emitter screen in
the center of the hood and align the mounting holes. Insert (4) screws from the outside.
Tighten securely. Please note that the mesh band end of the emitter screen is placed
towards the burner, not the hood.
Step 8
Turn the hood/emitter screen assembly over
and place it on the heater post. Make sure
all four of the mounting tabs are inside the
emitter screen. Line up holes in screen with
tabs.
Install four screws and tighten securely.
X 4
X 4