E-flite Carbon-Z Splendor BNF Basic - Manual (Page 8)

EN
1. Remove the canopy hatch before installing the wings .
2. Slide the wing tube ( A) into the fuselage.
3. Install the left and right wing ( B and C) over the wing tube and into the wing
slot of the fuselage while inserting the aileron servo connectors through the
provided holes.
4. Invert the fuselage so the landing gear is facing up. Secure the left and
right wings to the fuselage using the 4 included screws ( D).
5. Connect the aileron servos from the wings to the Y-harness connectors in
the fuselage. The left and right aileron servos can be connected to either
side of the Y-harness.
6. Replace the canopy hatch on the fuselage. Engage the latch so that the
front edge of the canopy is flush with the fuselage.
Disassemble in reverse order.
Installing the Wings
A
B
C
D
CAUTION: DO NOT crush or otherwise damage the wiring when
attaching the wing to the fuselage.
IMPORTANT: Correct operation of the AS3X system requires connection of both
ailerons to the included Y-harness and the AILE channel of the receiver.
If needed, use hemostats or pliers to pull the servo connectors
into the fuselage.
Tip
The CG location is measured from the leading edge of the wing at the root. This
CG location has been determined with the recommended Li-Po battery installed
near the rear of the battery compartment.
150mm
back from leading
edge at the root.
Center of Gravity (CG)
8