E-flite Ultra Micro 4-Site BNF User Manual

Page 6

Please follow these steps to charge your single-cell Li-Po battery with the Celectra

4-port Li-Po charger.

FOR PORTABLE USE:

• Remove the cover on the bottom of the charger and install four D-size batteries (not

included), noting proper polarity. Replace the cover after the Alkaline batteries are

installed.

• Use the included E-flite 6V, 1.5-Amp AC/DC Power Supply (EFLC1005/

EFLC1005AU/EFLC1005EU/EFLC1005UK).

NEVER attempt to power the charger from an AC outlet without the use of a proper

AC to DC adapter/power supply.

Note: When using the AC to DC adapter/power supply, the Celectra 4-Port Charger

is designed to bypass the D-size battery circuitry to prevent damage. Do not insert

charged or discharged Li-Po batteries in any of the charge ports if the power supply

is connected to the 4-port charger while power supply is not connected to a power

source. Doing so will discharge and possibly damage the batteries.

NEVER LEAVE THE ADAPTER/POWER SUPPLY OR CHARGER PLUGGED IN

UNATTENDED.

Celectra 4-Port Li-Po Charger Warning

Lithium Polymer (Li-Po) batteries are significantly more volatile than other

rechargeable batteries used in RC applications. Failure to read and follow these

instructions and safety precautions may result in fire, personal injury and damage to

property.

E-flite, Horizon Hobby, Inc., its retailers, and any other representatives, assume

absolutely no liability for use of this product or failure to comply with these

instructions and precautions.

If you are not prepared to accept complete liability for the purchase and/or use of

this product, you are advised to return it new and unused to the place of purchase

immediately.

Never ship batteries without the expressed permission of the recipient. Batteries

carrying a charge of 25% or more cannot be shipped safely. Batteries which are

damaged cannot be shipped safely. Damage or loss due to unsafe shipping is the

legal responsibility of the person who shipped the product.