E-flite P-51D Mustang BNF Basic - Manual (Page 4)

EN
Model Assembly
Wing Installation
1. Connect the fl ap servo connector to the receiver port number 6.
2. Connect the retract Y-harness connectors to the GEAR port number 5 and
the aileron servo connectors to the AILE Y-harness. The left and right servos
can be connected to either side of a Y-harness.
IMPORTANT: Correct operation of the AS3X ® system requires connection of
both ailerons to the included Y-harness and the AILE channel of the receiver.
NOTICE: DO NOT crush or otherwise damage the wiring when
attaching the wing to the fuselage.
4. Insert the guide pins (A) on the rear of the wing in the fuselage plate holes
(B), then connect the wing to the fuselage using 2 screws (C).
Tip: Carefully support the aircraft while installing or removing screws.
5. Install the scoop (D) on the rear of the wing using medium CA as shown.
NOTICE: Keep glue away from the fl ap torque rods and the fuselage or the
aircraft will not operate correctly.
When needed, disassemble in reverse order.
Horizontal Tail Installation
1. Slide the horizontal tail tube (A) into the hole in the rear of the fuselage.
2. Assemble the 2 piece (left and right) horizontal tail (B) as shown. Ensure
the control horn faces down.
3. Apply 4 pieces of tape (C) to the fuselage mounts (one on the top and
bottom of each half of the horizontal tail).
4. Attach the clevis to the elevator control horn (see instructions for clevis
connection).
When needed, disassemble in reverse order.
FPO
Flaps
Gear
Required Adhesives:
Medium CA
A
B
C
D
A A
B
C
B
4