Bosch ROTOZIP RZ18V - Manual (Page 18)

-18-
Overtightening the lock lever
adjustment screw
can
permanently damage the locking mechanism.
Test the tightness of the lever after each full
turn of the adjustment screw.
! CAUTION
LOCK LEVER
COLLAR
DRIVE BIT
WHEEL GUARD
LOCK LEVER
GUARD
LOCK LEVER
ADJUSTMENT
SCREW
SHAFT LOCK
LOCK LEVER
ADJUSTMENT
SCREW
INSTALLING ABRASIVE WHEELS
Always use the arbor nut that has same
thread size as the output shaft.
1. Install abrasive wheel onto output shaft.
2. Thread arbor nut provided onto
output shaft finger tight, depress shaft lock
and tighten wheel with the wrench provided
(Fig. 3).
Do not overtighten. Cracks
in the wheel can occur if
overtightened. Use wrench provided with
tool. Other wrenches may promote
overtightening.
Do not depress shaft lock
while the tool is running.
Depressing the shaft lock may cause wheel
to spin off or damage to attachment.
! WARNING
! WARNING
GUARD
ABRASIVE
WHEEL
ARBOR
NUT
OUTPUT
SHAFT
SHAFT
LOCK
Operating Instructions
MAKING A CUT
1. Make sure material being cut is secured in
a vise or fixture before attempting to cut.
2. Keep your body positioned to either side of
the wheel, but not in line with wheel. It is
important to support the tool properly and to
position your body such as to minimize body
exposure from possible wheel binding and
recoil.
3. Grip the tool with both hands when cutting
and always be ready and able to manage the
cut.
4. Avoid jamming, twisting or pinching the
wheel with the workpiece or otherwise
applying excessive side pressure to the
wheel.
5. Keep guard covering between wheel and
user.
6. Make sure the guard lock lever is in the
closed position and the guard is securely
mounted to the attachment. Use the allen
wrench to adjust the guard adjustment screw.
7. Maximum cutting depth is 11/16”.
FIG. 2
FIG. 3
COLLET NUT
OUTPUT
SHAFT
COLLET
RZ 2610925600 9-05 9/1/05 11:04 AM Page 18