Bissell 1620 - Manual (Page 17)

WARNING:
To reduce the risk of fire,
electric shock, or injury,
unplug machine from
outlet before servicing.
Reduced spray or no spray.
Possible Causes Remedies
Bladder may be empty Turn power OFF, refill tank with hot tap water.
SmartMix may be empty Refill bottle with formula.
The lint screen may be clogged Turn power OFF, clean out lint screen,
follow step 2 on page 8.
Tank-in-Tank may not be seated properly Turn power OFF; remove and reseat tank.
Pump may have lost prime Turn power OFF; after 1 minute, turn
ON and depress Spray trigger.
The Pump Belt may be broken Turn power OFF and unplug machine
from outlet. To check if a Pump Belt
has broken, you will need a flathead
screwdriver. Insert the blade
end into the lower slot of the Belt
Access Door to release the latch.
If necessary, insert the blade end into
the upper slot to release the upper
latch. Examine for belt breakage. You
should be able to see the Pump Belt
looped around the motor shaft. If it is
broken or missing, please refer to the
part numbers and descriptions on
page 19 before calling BISSELL
Consumer Services. Complete
installation instructions will accompany
the replacement belt.
DirtLifter PowerBrush does not turn.
Possible Causes Remedies
The Brush Belt or Pump Belt Turn power OFF and unplug machine
may be broken from outlet. To check if a Brush Belt
has broken, you will need a flathead
screwdriver. Insert the blade
end into the lower slot of the Belt
Access Door to release the lower latch.
If necessary, insert the blade end into
the upper slot to release the upper
latch. Examine for belt breakage. If
broken, refer to pages 13-16.
Lift Here
Insert
Screwdriver
Blade Here
Troubleshooting
1
2
1
2
3
4
5
6
3
4
5
6
1 1