Belkin F1DP116SEA User Manual
Page 19
15
section
Network Configuration
Network > IP Config
The page to the left shows the IP configuration items.
1. For
IP mode — You can press the SPACE bar to select Static mode or DHCP
mode.
2. For
IP Address, Subnet Mask, Default Gateway, Primary DNS, and Secondary
DNS — You can change these network settings.
3. After changing the settings and the final enter, the Console Server will prompt you
to confirm YES or NO. If YES, the Console Server will reboot and save the settings
into the flash memory.
Network > Current IP
To show the current network settings.
Network > IP Filter
To enable/disable IP filter function.
System > Reboot
To reboot the Console Server.
System > Reset to Default
To reset configuration to factory-default settings.
Note: Only the admin user has the privilege to perform this function.
System > Status
To show the system status.
S-to-S > Select Serial-to-Serial Port
To enable serial port-to-serial port connection through port 16. Refer to the “Serial-to-Serial
Function” section on page 34 for more details.