Britax Wizard - Manual (Page 18)

Care and Maintenance
33
Care and Maintenance
32
Cover Removal
1 Loosen the harness by lifting the harness adjuster lever while
pulling the harness straps forward as far as possible.
2 Unhook the harness straps from the yoke on the rear of child
restraint.
3 Remove the belly pad from the buckle.
4 Pull upper harness straps through the shell and cover, to the front
of the restraint.
5 Remove the comfort pads.
6 Gently remove the headrest cover. Be careful not to damage the
energy absorbing foam.
7 Pull the lower harness straps, buckle tongues, chest clip, and
buckle through the slots in the cover.
8 Remove the seat cover by sliding it over the headrest, through the
large opening in the cover.
WARNING:
• Do not take apart or attempt to take apart the harness. It is
unnecessary and dangerous to do so.
• Never remove the buckle tongues from the harness. They
cannot be reattached after removal.
Refitting the Cover
To refit the cover, reverse Cover Removal directions. Verify that the
harness straps are threaded through the chest clips and that the
harness is not twisted.
Cleaning the Cover
• HAND WASH, using cold water and mild soap.
• LINE DRY, to prevent cover from shrinking.
• DO NOT: Bleach, machine wash, machine dry, or
iron.
Cleaning the Shell
• SPONGE CLEAN, using warm water and mild soap.
• TOWEL DRY
• DO NOT: Use solvents, abrasive cleaners, or disassemble the
harness.
Cleaning the Harness
• SPONGE CLEAN, using warm water and mild soap.
• TOWEL DRY
• DO NOT: Bleach, machine wash, machine dry, or disassemble
the harness.
Cleaning the Harness Adjuster
Periodically check the adjuster area to be sure it is clean and free
of food, coins, dirt, and other objects. If debris is present, it must be
removed to prevent interference with the adjuster mechanism.
• BRUSH AWAY LOOSE DEBRIS, using a soft bristled brush.
• SPONGE CLEAN, using warm water and mild soap.
• TOWEL DRY
• DO NOT: Use solvents, abrasive cleaners, or disassemble the
harness.
P2285_R02c.qxd 12/8/2003 12:22 PM Page 34