Metrohm 930 Compact IC Flex Deg - Manual (Page 5)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
Table of contents
930 Compact IC Flex Deg (2.930.1160)
￭￭￭￭￭￭￭￭ III
Table of contents
1 About these Short Instructions 1
2 Introduction 2
2.1 Instrument description ......................................................... 2
2.2 Intended use ......................................................................... 3
2.3 Safety instructions ................................................................ 4
2.3.1 General notes on safety ........................................................... 4
2.3.2 Electrical safety ........................................................................ 4
2.3.3 Tubing and capillary connections ............................................. 5
2.3.4 Flammable solvents and chemicals ........................................... 5
2.3.5 Recycling and disposal ............................................................. 5
2.4 Symbols and conventions .................................................... 6
3 Overview of the instrument 7
3.1 Front ...................................................................................... 7
3.2 Rear ........................................................................................ 8
4 Installation 10
4.1 Setting up the instrument .................................................. 10
4.1.1 Packaging .............................................................................. 10
4.1.2 Checks .................................................................................. 10
4.1.3 Location ................................................................................ 10
4.2 Removing transport locking screws ................................. 10
4.3 Connecting the drainage tubing and leak sensor ............ 12
4.3.1 Installing the drainage tubing ................................................ 12
4.3.2 Connecting the leak sensor .................................................... 13
4.4 Connecting the eluent bottle ............................................. 14
4.5 Connecting the eluent degasser ........................................ 16
4.6 Installing the high-pressure pump .................................... 16
4.7 Installing an inline filter ..................................................... 16
4.8 Installing the pulsation absorber ...................................... 16
4.9 Injection valve ..................................................................... 16
4.10 Installing the detector ........................................................ 16
4.11 Connecting the sample degasser (optional) ..................... 17
4.12 Connecting the instrument to a computer ....................... 18
4.13 Connecting the instrument to the power supply ............. 19