Big Game Treestands CR4250-S - Manual (Page 27)

ADJUSTABLE SUPPORT BAR ASSEMBLY FOR CR4850-S
94
READ THIS MANUAL IN ITS ENTIRETY PRIOR TO USING THIS PRODUCT.
This Instruction Manual complies with the Treestand Manufacturers Association’s
TMS 04 - Standard Practice for Treestand Instructions & TMS 02 - Standard Test Method for Treestand Fall Arrest Systems
ADJUSTABLE SUPPORT BAR
STEP 1. Assemble adjustable support bar by
sliding tree piece into the ladder piece. NOTE:
The adjustable bolt cap will be used to set the
desired length of the adjustable support bar.
STEP 2. Attach adjustable support bar to ladder
using remaining bolts and wing nuts.
NOTE: These figures relate to Step 5 of the
Installation Instructions from page 90.
CONNECTING LADDER SECTIONS
WITH SAFETY SLEEVES
STEP 1. Place the Safety Sleeve over the top of
the middle ladder section.
STEP 2. Insert the Middle Ladder section into
the Top Ladder Section so that the Safety Sleeve
is on the outside of both ladder pieces.
STEP 3. Insert the Snap Pin through the
predrilled holes of the Safety Sleeves, Top Ladder
Section and Middle Ladder Section to connect
all pieces together. NOTE: Be sure that the
predrilled hole of the Safety Sleeve is assembled
to the top of the assembly.
Safety
Sleeve
Safety
Sleeve
Snap
Pin
Snap
Pin
Ladder
Section
Ladder
Section
Ladder
Section
Adjustable Support Bar
Tree Piece
Adjustable Support Bar
Ladder Piece
Adjustable
Bolt Cap
ADJUSTABLE SUPPORT BARS
STEP 1. Assemble adjustable support bars by sliding Part A into the Part B.
NOTE: The snap pin will be used to set the desired length of the adjustable support bars.
STEP 2. Attach support bar to ladder using remaining bolts and wing nuts.
NOTE: These figures relate to Step 5 of the Installation Instructions from page 90.
BgTLS0112Ar.QE_StandManual_1/06.QE 1/9/12 3:22 PM Page 94