Metrohm NIRS XDS RapidContent Analyzer - Manual (Page 38)

36 ▪▪▪▪▪▪▪
Vision asks if the default directory location is
acceptable.
Click on “Yes”. Vision creates a directory for the
project as shown.
Vision prompts the user to connect to the
instrument. Be sure the instrument is turned on
and is ready.
Click on “Acquire New Data”.
This screen sets up communication parameters
for the instrument. The XDS instrument has a
unique driver. Highlight this box and click on
“Configure”.
This box allows the user to set
the COM port and select the
instrument IP (Internet Protocol)
address.
Use the drop-down arrow of
the IP Address box, and select
the correct instrument. The
instrument must show
“Available” to be selected.
Click “OK” to exit the dialog box.