Metrohm 930 Compact IC Flex SeS/Deg - Manual (Page 5)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
Table of contents
930 Compact IC Flex SeS/Deg (2.930.1460)
￭￭￭￭￭￭￭￭ III
Table of contents
1 About these Short Instructions 1
2 Introduction 2
2.1 Instrument description ......................................................... 2
2.2 Intended use ......................................................................... 4
2.3 Safety instructions ................................................................ 4
2.3.1 General notes on safety ........................................................... 4
2.3.2 Electrical safety ........................................................................ 4
2.3.3 Tubing and capillary connections ............................................. 5
2.3.4 Flammable solvents and chemicals ........................................... 6
2.3.5 Recycling and disposal ............................................................. 6
2.4 Symbols and conventions .................................................... 6
3 Overview of the instrument 8
3.1 Front ...................................................................................... 8
3.2 Rear ........................................................................................ 9
4 Installation 11
4.1 Setting up the instrument .................................................. 11
4.1.1 Packaging .............................................................................. 11
4.1.2 Checks .................................................................................. 11
4.1.3 Location ................................................................................ 11
4.2 Removing transport locking screws ................................. 11
4.3 Connecting the drainage tubing and leak sensor ............ 13
4.3.1 Installing the drainage tubing ................................................ 13
4.3.2 Connecting the leak sensor .................................................... 14
4.4 Connecting the eluent bottle ............................................. 15
4.5 Connecting the eluent degasser ........................................ 17
4.6 Installing the high-pressure pump .................................... 17
4.7 Installing an inline filter ..................................................... 17
4.8 Installing the pulsation absorber ...................................... 17
4.9 Injection valve ..................................................................... 17
4.10 Suppressor .......................................................................... 17
4.10.1
Inserting the rotors ................................................................ 18
4.10.2 Connecting the suppressor .................................................... 19
4.11 Metrohm CO
2
Suppressor (MCS) ....................................... 22
4.11.1 Connecting the MCS ............................................................. 22
4.11.2 Installing adsorption cartridges .............................................. 22