Metrohm 940 Professional IC Vario ONE/SeS/Prep 2 - Manual (Page 5)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
Table of contents
940 Professional IC Vario ONE/SeS/Prep 2 (2.940.1420)
￭￭￭￭￭￭￭￭ III
Table of contents
1 About these Short Instructions 1
2 Introduction 2
2.1 Instrument description ......................................................... 2
2.2 Intended use ......................................................................... 4
2.3 Safety instructions ................................................................ 5
2.3.1 General notes on safety ........................................................... 5
2.3.2 Electrical safety ........................................................................ 5
2.3.3 Tubing and capillary connections ............................................. 6
2.3.4 Flammable solvents and chemicals ........................................... 6
2.3.5 Recycling and disposal ............................................................. 7
2.4 Symbols and conventions .................................................... 7
3 Overview of the instrument 9
3.1 Front ...................................................................................... 9
3.2 Rear ...................................................................................... 11
4 Installation 13
4.1 Setting up the instrument .................................................. 13
4.1.1 Packaging .............................................................................. 13
4.1.2 Checks .................................................................................. 13
4.1.3 Location ................................................................................ 13
4.2 Removing the handle ......................................................... 13
4.3 Removing transport locking screws ................................. 14
4.4 Connecting the drainage tubing and leak sensor ............ 16
4.4.1 Installing the drainage tubing ................................................ 16
4.4.2 Connecting the leak sensor .................................................... 17
4.5 Column thermostat ............................................................ 18
4.6 Connecting the eluent bottle ............................................. 18
4.7 Connecting the eluent degasser ........................................ 20
4.8 Installing the high-pressure pump .................................... 20
4.9 Installing an inline filter ..................................................... 20
4.10 Installing the pulsation absorber ...................................... 20
4.11 Injection valve ..................................................................... 20
4.12 Suppressor .......................................................................... 20
4.12.1
Inserting the rotors ................................................................ 21
4.12.2 Connecting the suppressor .................................................... 22